Featured
Gecko Spa Pack 3 Flashing Dots
Gecko Spa Pack 3 Flashing Dots. Shut power off and power your spa up again to reset the system. System may detect error condition if spa filter is dirty or if something restricts flow of water in piping.
Shut power off and power your spa up again to reset the system. System may detect error condition if spa filter is dirty or if something restricts flow of water in piping. Call your dealer or service supplier if problem persists.
Three Flashing Dots Appear Tub Very Slowly Cools But Stops Heating Beyond Current Temperature.
System may detect error condition if spa filter is dirty or if something restricts flow of water in piping. Please refer to the spa user manual to identify the configuration of your spa. System may detect error condition if spa filter is dirty or if something restricts flow of water in piping.
Refer To Hl Pages Of This Manual To Correct The Problem.
3 flashing dots appear on the display! Check and open water valves. Do not enter the water!
The Heater Will Automatically Shut Down When Error Condition Occurs.
Hi, our spa (about 10 year old) with a spa builders s class board isn't really heating. If so, remove your filters and see if the problem disappears. Do not enter the water!
Check The Led Board To See If There Are Three Flashing Dots On It.
Instead it means the pump stays on all the time as it realises it’s below target temperature. I have three flashing dots and a red light on the circuit board illuminated on a gecko 240v control pack. I have replaced the pressure switch, all t.
Follow Flashing Dots & Led Flow Chart.
I have a 2005 artesian spa and i think it uses a gecko controller. 3 flashing dots are displayed. 3 flashing dots appear on the display!
Popular Posts
Rabbitmq Filter Messages In Queue
- Get link
- Other Apps
Comments
Post a Comment